Q1:    How many batteries do I need for my NewCDbot?

A1:    You will need 4-AA batteries and 1-9volt battery.

Q2:    Can I use rechargeable batteries in my NewCDbot?

A2:    Definitely and in fact we encourage you to use rechargeable batteries.

Q3:    How do I change the (4)-AA batteries on my NewCDbot?

A3:    Unsnap the AA-battery holder and then slide back the bottom cover as shown below. Pull out the old batteries, insert the new batteries, slide the bottom cover back into place, and then press the AA-battery holder back into place atop your NewCDbot and you are done.

Q4:    Besides batteries, what else do I need to buy before I can begin using  my NewCDbot?

A4    Nothing, the NewCDbot Kit comes with everything you need to get started, except batteries.

Q5:    How difficult is the NewCDbot to assemble and how many tools will I need?

A5:    Currently the Kits are being shipped assembled, but in case you take apart your robot check out the assembly instructions here.

Q6:    Do I have to know how to program to use the NewCDbot ?

A6:    No, you can use the NCPS software and easily program your NewCDbot without knowing how to write code.

Q7:    What if a part on my NewCDbot becomes damaged?

A7:    Contact us and we will set you up with the proper replacement part(s).

Q8:    How do I program my NewCDbot with behavior?

A8:    Check out the NCPS Tutorials.

Q9:    How do I configure the Programming Cable for the OOPic controller in the CPC?

A9:   Check out the NCPS Online Manual.

Q10:    I have tried to configure my OOPic Programming cable, but it can't seem to find my cable!

A10:    Some Laptop parallel ports and even desktop pc parallel ports don't have enough power to drive the programming cable for the OOPic I. If you have access to another computer, then try the parallel port on that one. The second option is to contact us about upgrading to an OOPic-R controller, which is programmed via the serial port. The third option is to return your NewCDbot Kit for a refund.

Q11:    What should I do to prepare my NewCDbot for storage?

A11:    Remove the (4)-AA batteries and the (1)-9volt battery. The 9-volt battery should be removed even during short periods non-usage. This will help to prevent warping of the top and bottom CDs.